on vidio DIY Automatic Water Level Controller using NE555 Part 1

 

Hello friend's In this video we will see How to make AUTOMATIC WATER LEVEL CONTROLLER using timer IC 555
Working- When the water level goes below 'low-level sensor', the connected motor will automatically Start and when water reaches 'high-level sensor' motor will automatically Stop.


Components required:-
-----------------
1)PrefBoard (DOT PCB, Zero PCB, Vero Board, Prototyping PCB)
2)IC 555            -(1)
3)IC Base 8 Pin     -(1)
4)Relay 12v         -(1)
5)Transistor-
  BC547             -(1)
6)Resistors
  2.2k X 2
   10k X 3
   1M  X 2
7)Capacitor
  0.01uF (code for this capacitor is 103)     -(1)
8)Diode
  1N4007            -(1)
9)LED
  Red-(1),Green-(1)
10)PCB Screw Terminal Block(Optional)
   2Pin-(1),3Pin-(1)
11)Female DC Power Jack Socket(Optional)      -(1)
12)12v DC Adapter 1A.

 

Hello friend's In this video we will see How to make AUTOMATIC WATER LEVEL CONTROLLER using timer IC 555
Working- When the water level goes below 'low-level sensor', the connected motor will automatically Start and when water reaches 'high-level sensor' motor will automatically Stop.


Components required:-
-----------------
1)PrefBoard (DOT PCB, Zero PCB, Vero Board, Prototyping PCB)
2)IC 555            -(1)
3)IC Base 8 Pin     -(1)
4)Relay 12v         -(1)
5)Transistor-
  BC547             -(1)
6)Resistors
  2.2k X 2
   10k X 3
   1M  X 2
7)Capacitor
  0.01uF (code for this capacitor is 103)     -(1)
8)Diode
  1N4007            -(1)
9)LED
  Red-(1),Green-(1)
10)PCB Screw Terminal Block(Optional)
   2Pin-(1),3Pin-(1)
11)Female DC Power Jack Socket(Optional)      -(1)
12)12v DC Adapter 1A.