How to make High power Led light using 20w led light at home.
In this video I well show you how to make high power led light at home using 20w led light. The light is used for nite home, picnic light, using a flashlight etc. It is very simple and very powerful full light.
By this method you can make your own flash light or outdoor light. In this case I used 12 volt 10 watt led. All LEDs connected parallel. So input voltage is still 12 volt DC. As a driver you can use 12 volt 5 Amp SMPS or 12 volt 7 Amp battery.
Parts:
1) Old CPU heat sink and FAN
2) 12 volt 10watt LED (4pcs)
3) Heat shrink tube,
4) wires & battery clip
5) 12v 5amp SMPS (if needed)
This video show, the DIY homemade high-power flasher 12v 20w SMD LED Light using 3.7v 18650 Li-ion Rechargeable light then produces 1800 Lumens (Part-2)
Hell Guys in this project I use total 12 10 watt led. As this kind
of led get very hot you need proper heat sink. I run all of the led at half power around 5watt so that it life increases and it becomes more energy efficient.
Those LED support max 12V, 1amp. I found ruining those led at 9.5v 1amp is stable. also increase the life of those high power LEDs.
You can use two of those LEDs in series and use a 19v laptop power supply, or you can use a 12v power supply and use a buck converter to reduce the voltage to 9 to 10v.
Please don't connect with 12v lead acid battery with it. it will fry the LED.
How to make High power Led light using 20w led light at home.
In this video I well show you how to make high power led light at home using 20w led light. The light is used for nite home, picnic light, using a flashlight etc. It is very simple and very powerful full light.
By this method you can make your own flash light or outdoor light. In this case I used 12 volt 10 watt led. All LEDs connected parallel. So input voltage is still 12 volt DC. As a driver you can use 12 volt 5 Amp SMPS or 12 volt 7 Amp battery.
Parts:
1) Old CPU heat sink and FAN
2) 12 volt 10watt LED (4pcs)
3) Heat shrink tube,
4) wires & battery clip
5) 12v 5amp SMPS (if needed)
This video show, the DIY homemade high-power flasher 12v 20w SMD LED Light using 3.7v 18650 Li-ion Rechargeable light then produces 1800 Lumens (Part-2)
Hell Guys in this project I use total 12 10 watt led. As this kind
of led get very hot you need proper heat sink. I run all of the led at half power around 5watt so that it life increases and it becomes more energy efficient.
Those LED support max 12V, 1amp. I found ruining those led at 9.5v 1amp is stable. also increase the life of those high power LEDs.
You can use two of those LEDs in series and use a 19v laptop power supply, or you can use a 12v power supply and use a buck converter to reduce the voltage to 9 to 10v.
Please don't connect with 12v lead acid battery with it. it will fry the LED.
No comments:
Post a Comment